dalers69

£200 to the door....I jus hope I get them sorted!!

By picks....I meant the pictures ;-)

Yea iv heard mixed reports about them but they were a good deal an save the tors eliminator kit an has be be an improvement over stock....are u sayin don't run them from the picks or cos they aren't properly synchronized? There not even on the bike yet...assembling them to see how it goes an this happens!! Should the slides fully close or should there be a gap at the bottom...been reading around an people say as long as there in sync its all good? I'm gonna try my best to see if can sort it!....jus fried cos their brand new an wasn't expecting this to happen!

http://s1296.photobucket.com/user/dalers86/media/DSC_01991_zpse140f0c9.jpg.html

http://s1296.photobucket.com/user/dalers86/media/DSC_02021_zps1e02b9e5.jpg.html

Hey guys first post on the site!! Bought my first banshee a month ago....rode it for 10 min then thot I'd check it out as had a bit of rev hang? Video's on YouTube under banshee rev hang...anyways I discovered two airless where the boost bottle went into the boots...ordered new boots and a stock balancer pipe...boost bottle are shit apparently!...I also found crazy jetting in the carbs an the tors a mess so i Ordered New oko 30mm from USA with my new reed boots (I'm in Ireland) So I jus received my two new oko 30mm carbs after 2 weeks of waiting!! I put the together and I have a problem...one carb slide fully bottoms out and the other bottoms out but leaves a gap! I have taken them apart an tried them in the other carb and one slide will not fully bottom out!! It was a nightmare putting the cable into the slide and I'm scared of breaking the white plastic bit that attaches to the end of the spring! I've adjusted them loads an if u look at the pics on my other introduction thread ull see what I mean....so is this normal? Will this ruin my engine if I install them like this? The cable is brand new motion pro that came with the carb....iv adjusted the screws at the tops of one carb to try make the gap in the slides as even as possible....any help would be much appreciated!! I'll try post some photos!!