JDively910

Looking for best set up for 521 super cub lock up setup... I currently have ballbearing lockup a d it works very well but was unsure if it would allow my to go any faster on a finger lockup just for shear rotating weight difference rhanks

Thanks

What is the best to set a oem stator button at as far as away from flywheel thanks for the help

Thanks.. I was going to put a radiator in the cooler with a pump (just wasn't sure of what type of pump to get,and where to get the quick connects/size) thanks again

Looking for cool down cart help and size of block off for water pump? It how you guys run your cool down carts

ill take the water pump cover my email is dively737yahoo.com

Arlo Cully made the chassis H.O.D full rigid. And the reason I said it didn't hurt et was due to I ran same mph same and same time.. That's all that was ment.. I understand the rotation mass.. I lightened my rear tires by 4lbs combined didn't seem to help much if any.. (Wasn't being smart wasn't arguing.. I'm not going to ask a question if I know the answer. I'm not stupid I understand the weight I'm pretty much saying is it didn't seem to effect it accordingly to the time slip

Full rigid chassis brand new jja axle with jja spacers with engine stay.. Not sand(500 ft clay where loss of traction at end of till then regaining traction.. And yes I do think k&t and asking the pro racer that I asked answered my question.. I understand that 530 is heavier I also understand that it robs hp never did it didn't ..what I said is it didn't hurt the et.. So thanks for the comments

Had my question answered by a professional that actually answered my question

521 super cub (137 hp done by k&t)an 530 on my 421 also the sprocket weight and extra chain weight does not make difference especially when. You snap every 520 chain made.

I'm looking to buy a bearing support wih the bearings and nut ..my number is 81450256zero0 thx

Hi I've never owned a bearing support but I want one just for the added support to the tranny shaft.. My question is do you have to special order a special but if you run 530 sprockets instead of 520? Thx for any information

As title says looking for jja hobda sprocket hub thanks paypl ready

Looking for vforce 3 reeds PayPal ready 814502five600

Interested in carbs

Bump

My number is 81450256zero0

I'm looking for 10x4 rims with tires; Banshee stock ignition(stator flywheel wires)

3300 shipped

Josh Dively on Facebook its on video and I have slips.. It's no joke I weigh roughly 182 go down the track weight and the bike weighs 240s

If you live in PA or MD I'll deliver for 3350

1-5 neutral down tranny

Up for sale is a 421 cub done by K&t.. Has straight cut gears Matton basket 4mil stroker crank vforce 4 reeds and intakes.K&t polished head. Shearer one out each chrome drag pipes custom made. Looking to get 3550 shipped.(engine has gone 5.804@103.87 in 500ft on 110 octane fuel) I ran 1 pass 300ft ran 3.80@87.89. Then comes complete ready to bolt in minue ignition and carbs.

Looking for Banshee override.. 1-5 neutral down billet 2nd.. My number is 814502560zero

Looking for Banshee override 1-5 neutral down billet 2nd my number is 814-50256zero0