turbosrt4
-
Posts
80 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Store
Posts posted by turbosrt4
-
-
well i guess its just the nature of the beast>service manuel even says to start a warm motor to open throttle
-
ordered a carb too' to check floats would that cause starting issues if there wrong like flooding?
-
got a new cdi still hard to start when warm acts flooded if i crack the throttle starts good ,i just dont get it
-
Ok checked caps 4.8 and the other 5.1
-
Get them from fast ?and i check the boots i can never get a solid steady reading at all two sets of caps all the same
-
how do i check the caps
-
so 6.5 is good
-
6.3 ohms
-
Ok ill try it
-
i have a ohm meter how do i check them
-
brand new
-
No i think i just need to get a dynatec ignition system
-
Elevation 850 pipes rockets two 421 cheeta built by cascade 180 psi vforce 4 reeds plus 5 timing 20 cc domes 95 degrees
-
no help tried two stators two coils and new wiring harness same old cdi
-
Ok as of now my jetting is 155 main cel needle 3rd clip 52 pilots runs good but dont want to start after its warm and has been sitting for 5 minutes .unless i crack the throttle, ive trie 50 48 and 45 pilots no change
-
still have not figured this out
-
i was thinking casscade
- 1
-
the slideswas not wrong but yea trying to get a info on thr two
-
whos a good builder for this
-
dalton ga and yes the washer is the i just took the carbs apart and checked everthing there clean
-
id the crank is out of sync it will cause a miss also have you ever seen one do that??
-
i have even taken the brass picse out that the needle goes threw are the holes in them are clean
-
and what do u think is wrong with them the carbs are clean jets are clean floats are set ,and sync with a brand new meter
-
its also getting fuel pulled the pipe on the left side fuel of fuel im pulling the motor
Alba plus 2 plus 1
in Banshee Repairs and Mods
Posted
just installed this kit what all shocks will work with them ?yfz 450r? kfx ?