max ertz

i dont have blue plastics . i like the 400 ex idea

any of those will do . just need a 4 stroke to ride along side my wife utility quad . hers is not the fast its only a 400 4x4.

i didn.t get your e=mail can you resend plz

if you can send me a e-mail i will shhot you pics with no problem . as the way of mods it has itp rims and tires , trinity pipes and silencers. black plastics with alba flame grafics .and i have some extra parts to go with it for the right deal . i need a 4 stroke to ride with my wife her quad is not that fast to run with me , [email protected] for pics

i am looking to trade my 1993 banshee for a decent 4 stroke . it needs reeds which i have on order and rear caliper rebuilt . have extra parts to go with the deal . i am in hillman michigan 49746 e-mail me for pics plz

pm me your shipping address

rear brake caliper

check the glow plug . also carb setting high speed 2,5 turns out low speed at 1,0 to 1.5 out . check all fuel lines lookat the line from the pipe to the tank make sure its not cracked or broken . and yes a crack in the exhaust will not allow it to run . not enough back pressure . where in pa are you at . i lived on the east side of the state .

i like seafoam but if i can get bg 44k i would use it when i worked in the garage its all i used

do you have the rear brake caliper

50.00 shipped on the clutch setup . i will do paypal

wow . i meant no disrespect to him . sorry if i did .

it was about 5 degrees warmer . i had to take the engjne out anyway to pit in a new trans . . it will just take me awhile to get her redone . coulld i have lost compression just on that on side , but what gets me is the one side is to hot to touch , and the side acting upi can wrap my hand around the pipe and not even burn myself who are those hot girls in your pic .

i bought this shee about a month ago . i guess i got someone mess . oh well now i can o it my way

just cleaned my carbs and filter last week . she ran fine this morning . then this afternoon i was in the sand riding . i got the engine out no holes on the pistons . tops are a little brownish with some black mixed in . is 0.75mm a stock bore or is that 75 oover . its been a while since i had one open .