natas

good thing im in utah

Just got a frame to build a hillshooter with. with no title and no visible vin on it how do i go about getting a title ? Thanks in advance !

This is a used but in good shape vito's 4 mill crank with 110 rods $280 plus the ride located in ogden utah 801-458-4842 Ryan

top of the heap

need the cash more than anything . I could do only half trade. [email protected] 801-458-4842

sorry it should of said 100 oct

K&T kim muchmore . trade ?

top of the turd heap

tippy top

2001 fresh 7mill cheetah cub engine 68mm blaster pistons 19 k&t cut bb domes k&t head cpi big bore pippes cascade billet covers on motor 40mm lectron power jet carbs comes with needles to run alcohol 6in eyeball engineering swing arm come check it out there are much more parts on this bike. also comes with ten paddle hauler tripple buffed on race cut wheels one paddle has a plug in it but works great more pics on the link. located in north ogden utah Thanks Ryan $3500.00 firm 801-458-4842 Ryan http://www.ksl.com/index.php?nid=218&ad=13449557&cat=145 this is on 91 oct bad boy side sand mountain utah

shoot me a price it never hurts

Thanks !!!

top

up for sale is a set of cylinders look to be in great shape took off my running bike stock bore no port work . these are on ebay just bid $210.00 for them and let me know your from the forum item # 230547257672 located in ogden utah

who did the port work ? and what rods are on your crank 115 ? Thanks

send a pic to [email protected] very interested

looking to swap out my wifes twist throttle for the stock thumb throttle .anyone have a good thumb throttle they want to sell ???

Looking for a good set of sb inframe cpi stingers and mufflers.let me know if you got any or a line on sum. Thanks !

Nicklsiled not buckled

.little more info on it.the cheetah cub was just re buckled and brand new blaster pistons from k&t performance

I haven't checked that yet. Just pulling the head off now.what should the compression be at 4000 feet and 19 cc domes

Thats the thing just rebuilt carbs swaped over to gravity feed and gas needle . idles fine runs at low speed fine but once i get on it it starts to choke. it might be a little to rich.also i have 19cc big bore dome should i swap them for a different size ? Thanks for any help

so do you just run fuel pumps on alky? or can you run them on gas? I have a 7 mil stroker 443 with 40mm lectons. Thanks in advance

looking to replace my axle.need a good used hillshooter axle let me know what ya got

Trying to decide what axle to buy. just for hill shooting on a 7mill cub 443cc . any advice is greatly appreciated