bansheeqc

Thank Brandon for the info. I finally don't buy the lectron. I will stay with my 39 pwk for now.

thank Cam for the information. I finally don't buy the carb. I think n2otoofast give me a good advice... I will stay with my 39pwk.

Sound good to me.. . It's probably what i will doing if I'm not able to obtain some information.

Sorry for the bad link. This is the good one. http://i426.photobucket.com/albums/pp343/bansheeqc/lectron.jpg

as posted in the jetting section with no luck: Hi, i need some input about Lectron carbs. A guy sell a set of 38mm lectron, and i want to know if this carb it's good for a 4mill stocks cylnder drag bike. (see picture for the carb. I know the lectron run wirth interchangeable metering rod to set the carb on gas or alky. So, i want to know if it's good carb, how to set up lectron (méthanol vs gaz, pump or not? if someone have a idea of set up to put in this carb, where to go to get parts... The actual owner of the carb don't know anything about the carb, they never run it on his bike. I want to be certain that the carb will run properly on a banshee...If anyone have some information about this carb (look at the picture in the link below)...model of carb ... Thank you Bansheeqc http://i426.photobuc...eqc/lectron.jpg

Thank Steeve for the info...< I will try in the drag forum. Bansheeqc

Hi, i need some input about Lectron carbs. A guy sell a set of 38mm lectron, and i want to know if this carb it's good for a 4mill stocks cylnder drag bike. (see picture for the carb. I know the lectron run wirth interchangeable metering rod to set the carb on gas or alky. So, i want to know if it's good carb, how to set up lectron (méthanol vs gaz, pump or not? if someone have a idea of set up to put in this carb, where to go to get parts... Thank you Bansheeqc http://i426.photobucket.com/albums/pp343/bansheeqc/lectron.jpg

You are able to stretch the oring to pass over the crank web?

Okay, thank you NYUK. It's best to put the cut side on the top, bottom, side?

I split the case of one of my drag bike with a 4 mill 115 rod hot rod crank. I want to know if it's possible and how to replace the o-ring of the crank in the center. I change a couple of time the o-ring on the outside bearing, but on the center, i'm not sure if it's possible... If not, what are you doing to fix? thank you

Salut Kero Bienvenue sur le site. Quel région de la france habite tu?

What is the advantage to have heavy arm? DD or GRR it's the best? I know with heavy arm, no need to put bolt on the arm.But heavy arm hurt anything? Input needed! Thank you

How much: it's depend of the reliability you want. Generaly, it's not the intake the problem... I do it a couple of time on my 513 and ended up with broken skirt... On the seat, I don't feel any difference widened or not. Just an advice.

Thank you Dave for the precious information. I think my hinson have around 3/4 inch or so more than OEM unit. I double check as soon as i can the extra space and i post it.

Any one??