shortburb

well I take that back. Im seeing about $260 for wiseco pistons and boring service...might do that

iv been doing some looking around and these appear to be stock pistons. Im sure you will think Im cheap but can I buy a set of OE rings and head/base gaskets and put it back together? i dont want to spend the money/time on boring the cylinders right now. this thing needs freshened up not a whole crispy top end ya know

Both holes made 70 psi thats why I am doing a top end. Ring end gap is huuuuuuuge. id be content just doing rings and top end bearings but i want to fgure out what pistons are in it.

Hey guys sorry for the rookie question. I didn't get far with the search feature Iv had this banshee for a bit and it needs a top end. Pistons measured at 63.4 and bores measured at 63.5. Standard bore is 64.0mm right? I will get another micrometer and check it against mine, other than my mic being off-is a smaller than stock bore thing common? Im afraid to order 64mm pistons and they don't even go into the bores... This is an stock bike less air box lid removal and a pod filter. I haven't even spent time messing with jetting because it runs fair and doesn't foul plugs. Id like to order pistons soon