lick

I do agree with all of you. The only thing I was worried about was the bearings being kinda messed up due to the metal shavings and such. Then again if it checks out OK, I'll stuff it back in. Thanks

Hi, Well the shee began to run a little slower then normal. It still ripped but just didn't feel all there. Anyways pulled the top end off and the left cylinder kicked out the cir-clip and the wrist pen tore into the wall. Went kinda deep. The cylinder didn't clean out till 1mm over. So back to the question at hand. The crank looks OK and seems to be fine, but I'd like to have it rebuilt for a peace of mind. What is a decent place that's not to expensive to send it out to. Any info on this would be great. Thanks