rotty150

He guys I need some drag pipes for a small bore 7 mill stroker 420 banshee, I would like to get same side but if the price is right I may do one out each side, if you got something please send me a pic to [email protected], I dont get on here very often so please use that e-mail. thankx Brian

i'M LOOKING FOR SOME CHROME SAME SIDE DRAG PIPES, MUST BE IN GOOD CONDITION WITH NO DENTS.

I am located about 45 min west of boise towards the oregon border and yes, that bike in my avatar is for sale also, it is a 2005 overhauled yfz450, stroked 5mm and bored to 98mm, +6 swinger, very nice bike also $6500

Here ya go guys, I just finished this bike last week, The red billet kick starter came after the pics were taken so it does have that on now, this bike has only been fired up not ridden, This bike is basically a brand new 2002 totally over hauled from the bare frame up, it is a 7 mill K&T built drag motor, 110 race fuel or higher. This bike is going to be extremely fast. New everything on this bike, everything is polished, billet or chromed. Located in Idaho 208-405-5025 Brian

pm sent

2000ft sorry not 200

Hey guys can you give me an idea of a starting point on jetting/needle clip my 34 pj's at 200ft. Mods are K&T built 7 mill, 110 race fuel, cpi inframes.

SOLD!!!!

Looking for same side drag pipes or possibly side by side? Would like same side better.

I have some nice 35.5 mikuni carbs with power jets and K&N filters "i forgot to put them in the pic" and a ton of mikuni jets. $500

I'm looking for some nice side by side drag pipes for my 7 mill build, must be in good shape, no trash dinged or dented or chrome flaking please, also need a nice billet grab bar, polished thumb throttle and polished rear brake system.. 208-405-5025 Brian

I got a 2003 complete banshee motor I took out of my wifes bike to build me a bullet bike, Motor is in great shape. I pulled the head off to inspect before I put it up for sale and everything looks excellent. It has a new head gasket, new polished clutch cover with new gasket, new water pump gasket, new o-rig and new kick start seal. Motor is stock bore, never been cracked open for any reason other than what I just did, excellent compression, tight tranny, this motor is ready to go, minus carbs, comes with intakes reeds, everything. I can e-mail pics of around the motor if you send me your e-mail. $1150 b/o + shipping Brian 208-405-5025 I am located in idaho