Ben

I can't agree with you more. It is just it might be until Dec that I get that part. It has already been ordered, but I have to wait for my brother in law to get here. The temperature out here is amazing (60F) and we live in the mountains with thousands of dirt trails... so we are just a bit impatient that's all. I got my mother to send me two complete rebuild kits, and it was a miracle I got them. I'm not sure if I understand well what you mean by the throttle adjustment, just tighten them a bit more when I sync the carbs? Maybe my best bet is to wait to get the part. Thanks for all of the responses. Ben.

These have a lock nut that hold them from falling out. http://www.vitosperformance.com/atv_parts/...=372&page=1 these are the ones. Thanks. I was reading the manual and looked at the diagram that comes with it and didn't find the part. I think that these were probably drilled manually at some point. Is it possible until I figure out how to get the part sent here (I'm in Spain right now, and this is actually my friend's quad) to cover the hole and adjust the idle with the normal air screws? ... It's prob not going to run right but for the time being it might just do. Thanks.

http://static.flickr.com/101/293200633_0f3c90f6e0.jpg?v=0

These are stock 28mm carbs off a 93 Banshee. It is the screws that are on the outside of both of the carb bodies. These are not the ones with the springs. Thanks again. I'll post a pick asap.

I lost the idle screw off my right carb. I bought a screw off bikebandit thinking it was the right one and it was not. I don't see the screw on the yamaha carb diagram... I can't find it anywhere. Any help would be greatly appreciated. Thanks.