mud91

what do the arrows from the presure plate suppose to line up with? How does that damn kick starter go back in. trying to get her running before sat. I was replacing the clutch rod/ball bearing and now can't seem to get her put back together. thanks

pics of the t-5s interested in them

no, just went for a ride down the road, turned around and clutch arm would not move..I need to get this running for next weekend.

not strong enough..funny..do the cases have to be split for this job? after searching i'm guessing the pushrod

come on guys need some help..

no it won't move at all. thinks its called push lever assembly, connects to the push rod.

My clutch is stuck..the cable connects to that lever on the tranny. I tried moving that lever and its stuck..any suggestions..

I just bought this bike a month ago and it does have a wicked trail port, just right below is dune port. Your right I did notice the the bottom end bogging..i did adj the air screws and seemed to help with 2.5 turns out compared to they were bottom out..it acutally pulls hard..but then again never had a ported banshee..I can say this, last weekend I raced alot of 450's w/exhaust, intake, programmer on a 260ft sand drag set up here at the local track. almost everytime they took me off the line, pulled them in around half track and won 1-2 bikes length. their was one 450 rider that weighed 125 lbs that actually beat me one time but I was pulling on him after a bad start..i weigh 250 by the way...I guess I just wanted to try a different pipe with my setup what it boils down to..

pics to salinas91@yahoo.com

my banshee has these mods; .40over, 35mm keihns w/pods, +4, coolhead 20cc, wicked hot trail port, Pro circuit plats.. how would fmf fatties react to what I have know: dmc : t5's: right now the midrange pulls like crazy..just looking for little more on mid to top..I didn't mention cpi/shearers becasue i can't affort them right now..

thanks for the info..

how much for the led's...also which ones from walmart to get me by for now...

where can I buy some replacement idle adjustment and air/fuel screws for these...

where can I get a set of lights for the shee..just bought it with no lights..

thanks for the info.