cheezehead69

i have a 99 shee with pipes boost bottle and a tors removal kit. all of a sudden when i was riding it it began to sputter at full throttel. so i changed the spark plugs and gas. then i took the cards out and cleaned them completey and still does the same thing. now the quad idels and strarts good but under any load it it sputters and spits and wont rev up. if anyone has any ideas that would be great. thanks

i filed them down to 3/4 of an inch just like it said. but the only thing i didednt was set the floats to 21mm will this matter. if so do you know how to do this.

according to the instructions it just says to set them at 21mm but does not tell you how. is it nessisary to do this or should i just leave it. and after i put the kit on the idle screws dont do anything when the bike is running they just turn in and out with no change. can anyone help

i just put a tors removal kit on my shee and it says to adjust the floats to 21mm. i am not sure how to do this. do you measeure from a certain place or what.

i am looking at changing my gearing to get more low end torqe. what size front sprocket should i run. or back sprocket .

does anyone know a good tors removel kit and where to buy one and what it should come with when i buy it.

i found the problem my choke tube was the slitest bit off. you couldent see it you had to get in there and play with it to see. thanks for all your help.

what do they look like. they probably are still on there the bike is stock

i have a 99 banshee and i resently replaced one of the carb tops. i reset everything back up and it wont start unless i pull start or use something like carb cleaner to get it going. once it is going you can drive it fine but it wont stay running at idle. does anyone hav any ideas what this could be because i am stumpped. thanks.