i just blew a top end and when i went to replace it i noticed that the rod moved moved up and down about 1/8 of an inch. i came to the conclusion that it was a bearing in the rod. i called the local shop and they don't know what the hell they are talking about. they told me it was better to buy a new crank than rebuild one on a twin cylinder engine. i see that they sell new replacement rods and bearings. i figured that nobody would have a banshee if everytime you have to replace a crank pin bearing you had to buy a new crank. i need help because i don't want to have to buy a new crank. they said it will have to be pressed on. i don't know if they were talking about the big crank bearing or the bearing in the rod. i just want to know what i have to do to replace this bearing.
