That is kinda vague...I was looking for something like, "the bottom end is kinda weak but hitshard in the middle and keeps on pulling to the top but not like drag pipes" Something like that.
Dustin
I am selling my 2n1 setup. They will be cleaned up and ready to go when you get it.
180 or reasonable offer/trade + shipping
Email me @ sambinksey@yahoo.com for pics.
Dustin
Ok here is my setup, hope this helps.
Stock motor
2n1 Dynoport
Stock carbs
Airbox lid off
K&N with proflow adapter
Reed spacers
FMF Carbon fiber power reeds
I run amsoil synthetic at 50:1
Jetting: Stock pilot 1.5 turns out
Stock needle one notch down from stock (richer)
310 mains
You could try the same as mine just run 290s since you have your lid on maybe even 280s. Just do a plug chop to verify.
It runs stong. I was having a problem with over heating so I went from a 300 to 310 just to see if that helped and damn I found more power so I must have been running too lean. I am going to try 320s this weekend to see if I can find some more!
Hope this helps. I used the Banshee jetting guide in the FAQ section to get close with my mods and it took alot of the headache out.
Dustin
Right now sheerider4life has dibs on the lights. If he doesn't come through "." you have dibs.
And yes the come with rubber, metal spacers, and bolts. Bolt, plug in and go!
Dustin
Stock headlights off an 03: Sold
Stock front shocks RED: 60 shipped
Stock tie rods with ends: 25 shipped
Clutch side cover sandblasted and ready (the whole cover not the insersts): 60 shipped
Dynoport Exhaust: 175 plus shipping or Trade for Fatties
Pics by request. Just pm or post.
Dustin