HARTZ55 Posted July 23, 2008 Report Posted July 23, 2008 hey my banshee, wont run bcus the floats r stuck/carbs need to be cleaned, i sent it into the shop, but for future reference with carbs and floats, how would i adjust the floats and take apart the carbs? Quote
hubmonkey Posted July 23, 2008 Report Posted July 23, 2008 hey my banshee, wont run bcus the floats r stuck/carbs need to be cleaned, i sent it into the shop, but for future reference with carbs and floats, how would i adjust the floats and take apart the carbs? Download the service manual that is stickied at the top of this forum. Hub Quote
HAUSERSMOTORSPORTS Posted July 23, 2008 Report Posted July 23, 2008 easy. pull of bowls, depending on how bad the floats are stuck id spray then with a little pb blaster and let it sit for a little bit. if you have it advance auto sells carburator cleaner in a bucket. its so much better than carb cleaner in a can. REMOVE EVERY GASKET AND O-RING!!!!!!!!!!! it will melt all rubber and paper gaskets. after this remove the needle and seat and all other jets and let them sit in the cleaner for about 15+ minutes depending how bad they are. DO NOT PUT THE FLOATS IN IT!!!! have a can of carb cleaner handy to clean out the jets and carb then blow it out with air. this is how i do mine all the time with zero problems. hope this helps. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.