shee runs like poo

[1996dragshee]

well after a whole rebuild on the trail shee and with some help from Dave (thanks bro) to get spark,only one side runs. i threw a rod bearing so i bought a crank and a set of stock cylinders and pistons.got it all back together and now only one side runs.

 

average stock banshee with T-5 pipes,stock carbs TORS revoved with 270 mains and 30 pilots. 115 compression on both and it holds

 

when its dead cold and i start it it fires on both cylinders but soon as it warms up the left side stops firing.it just shoots out cold exhaust with little pressure while the right side sounds awesome and rips.

 

i swaped out the coil and stator and flywheel and checked the pick up coil gap and i got nothin.so im lost and pissed off and im gonna burn this mother f*cker to the ground here pretty soon

 

ideas would do me good right about now,thanks fellas

[SHOWTIME]

how bout swapping out the cdi...

[lowbuckracing]

Do you run a coolhead?check to see if oring is leaking.check the plugs ..do comp test...Carbs in sinc?Cdi swap...PLease dont burn the shee!They are becoming an endangerd species and in 20 years only the good will survive..Let yours be one!!Lowbuckracing...

[1996dragshee]

lol.well fellas i got her running!! :biggrin:

 

just a pure rookie mistake.when i took the carbs off to do a little cleaning i didnt even check to see if the floats were moving properly. and my FIANCE says and i quote " did you take the floats off and clean inside the needle seat" LOL and sure as shit there was 2 pieces of sand stuck in there!! lol what a girl huh!?!

 

so shee rips and runs awesome but now just gotta adjust the clutch from the set screw thingy.shee moves but when i hit high gear and bop the throttle it feels like the clutch is partly pulled in

 

thanks for the replies though fellas,the CDI was gonna be my next step