dekker Posted March 18, 2008 Report Posted March 18, 2008 Picked up a set of 34mm tmx mikunis just wondering where to start my jetting. I ran 360's on my stockers my mods are in my sig.... I was thinking go up 3 or so sizes to start any help would be much appreciated. Zach Quote
Fireroad Express Posted March 19, 2008 Report Posted March 19, 2008 (edited) are you sure these are tmx's and not tm's? is the slide completely flat on both sides or is it "D" shaped.if you are looking at the air intake side(the bell end) of the carb the fuel spigot should be on the right side if its a tm carb. the tmx spigot is on the left. check out the mods and carb specs in my sig.keep in mind that the new carbs will flow alot more fuel through them than the stockers because of thier larger size, even with the same jets as the stockers. 360's should be a pretty safe place to start with these carbs. hope this helps. Edited March 19, 2008 by the grinch Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.