Hellfighter334 Posted March 6, 2008 Report Posted March 6, 2008 Ok, so I just installed the STEP 2 twist throttle kit with the Motion Pro Idle Kit. Install went great, except it seems that my cable is too short. At first my slides would not bottom out. Idle screws were all the way out and I bottomed out all my adjustment screws (carb tops and twist throttle) and they still wouldn't bottom out. I ended up trimming some plastic of the inner workings of the twist throttle just so that it would idle, but there is still no play in my throttle and I'm worried about breaking a cable. Any suggestions or help. Quote
fastrthnu Posted March 6, 2008 Report Posted March 6, 2008 Ok, so I just installed the STEP 2 twist throttle kit with the Motion Pro Idle Kit. Install went great, except it seems that my cable is too short. At first my slides would not bottom out. Idle screws were all the way out and I bottomed out all my adjustment screws (carb tops and twist throttle) and they still wouldn't bottom out. I ended up trimming some plastic of the inner workings of the twist throttle just so that it would idle, but there is still no play in my throttle and I'm worried about breaking a cable. Any suggestions or help. be sure you have it routed correctly and you dont really want any sharp bends, if it doesnt work see if you can send it back and get another one. I have the same setup, mine isnt showing much slack, but it wasnt a problem anywhere. Make sure you have it right up where the cable enters the throttle. See if you can scew it in at all to give up more slack and the same at the carb slides, there should be threaded ends you can screw in more. Quote
ClimbAnyHill Posted March 6, 2008 Report Posted March 6, 2008 You can also give it more slack by adjusting right above the carb caps. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.