4mm Cub DRAG STATS?

[Guest WICKED ATV]

what are some of u 4mm asphalt cub riders running in the 1/8 mile please include how your bike

is setup MAX HP- alky-race-pump , carb size, pipes, porting type if any, the builder. Trying to get an idea what to go with was going for a 10mm but may go with the 4mm. they sound pretty tuff!

[Big Blue]

There is alot of info on 4mm cubs on Plantetsand.

[reded]

I dont know about asphalt but I've got a 4mil cub that can put an ass whippin on a few 10mils in 300 ft sand drags.

 

The only downfall I can see to the 4mil in 1/8th mile would be that it wouldnt have the torque to pull as tall of a gear as the bigger motors.

Edited September 16, 2006 by reded

[Big Blue]

Bigboybanshee 350 seems to pull enough gear for the 1/8th but anything past that I would think tq would have an advantage.

[bigscary]

what are some of u 4mm asphalt cub riders running in the 1/8 mile please include how your bike

is setup MAX HP- alky-race-pump , carb size, pipes, porting type if any, the builder. Trying to get an idea what to go with was going for a 10mm but may go with the 4mm. they sound pretty tuff!

 

there are 4mm cubs running 6.2's in the 1/8th......N/A with 5 speed overrides.......

just go over to planetsand.....more information than you can read in a month.........

[race-a-holic]

Bigboybanshee 350 seems to pull enough gear for the 1/8th but anything past that I would think tq would have an advantage.

My alcohol stock cylinder(F.A.S.T) 350 has no problem pulling the 1/8th mile.Plenty of power when I cross the finishline.I run an 18/38 gearing.There is some very fast 4 mils out there.