badass_r6 Posted July 17, 2006 Report Posted July 17, 2006 im taking my friends motor apart an dont have a book..i need to know what the standard bore is so i know if this is oversized or not..i measuered 2" .575 ..does any one know this off hand thanks... Quote
[email protected] Posted July 17, 2006 Report Posted July 17, 2006 63.00 mm is stock I BELIVE , i could be wrong . Quote
RILS Posted July 17, 2006 Report Posted July 17, 2006 63.00 mm is stock I BELIVE , i could be wrong . 64mm is stock im sure. Quote
badass_r6 Posted July 17, 2006 Author Report Posted July 17, 2006 do you guys know what that would be in standard (") Quote
RILS Posted July 17, 2006 Report Posted July 17, 2006 do you guys know what that would be in standard (") I think its 2.54. Quote
2003LimitedBanshee Posted July 17, 2006 Report Posted July 17, 2006 Actually it would be around 2.52. There are 25.4 mm to an inch so. You measured 2.575 so you're at 65.405 mm, which sounds odd. But you'd be looking at a 65.5 mm at the least, don't know if that is possible to get it cleaned out in .10mm, but you should be able to go to 66mm if 65.5 doesn't clean it out. Usually min bore/hone is .010" which is .254mm so you're looking at going with a 66mm if I'm not asleep at the calculator. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.