tithead Posted December 2, 2004 Report Posted December 2, 2004 i was on the trinity site last night looking at the cheetah big bore kits for the banshee. which do you think would be better? the 400cc powervalve kit or the 420cc powervalve kit with stroker?????? what pipes would be a good choice to go with when doing this? tithead. Quote
00BANSHEE Posted December 2, 2004 Report Posted December 2, 2004 For what type of riding conditions. I was happy with the 400cc kit. Off the shelf it put out 80hp with 40+ ft lbs of torque. I ran T5, Trinity inframes, and CPI pipes with the CPI getting the nod for most low to top end power. Quote
banshee04le Posted December 2, 2004 Report Posted December 2, 2004 It's a 421 cheetah (4mil). The 420 is a stock cylinder trinity big bore setup. Obviously the 4mil is going to run a little stronger, but the 400 runs strong too. I agree that the cpi's would probably be your best bet. Quote
Big Blue Posted December 2, 2004 Report Posted December 2, 2004 (edited) I would go with the 485, 00BANSHEE who did your 400. Edited December 2, 2004 by Big Blue Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.