clutch basket

[bansheeboi]

im sure this might sound stupid but when you have to replace your clutch basket and you decide to go billet ive noticed that the new baskets dont come with the gear on them some im wondering do you use the gear of your stock basket? an if so how do you remove it. beside you wont know if you dont ask

[SAVAGE420]

The worst part about the job is grinding the rivets from the stock basket so you can get the gear off of it. I used an air powered die grinder with an 80 grit 3 inch Rol lock disc. You could use a small cut off wheel also. Then it just screws onto the billet basket, use lock tight on the screws (red) and don't forget to order the cushions if they aren't included with the basket. After that just install everything as normal and adjust the clutch also. An impact wrench helps when removing the clutch nut. It's 32mm. Not a bad job though. Real easy to do. A 2/10 on the (know what your doing scale)

 

I run the Magnum Billet Basket from Jeff (F.A.S.T) on here. Very nice piece for cheap.

http://www.farmandsandtoys.com/partdetail.asp?partid=39

[bansheeboi]

thanks for the info and that basket is the same one im looking to buy now thanks for the info

[AKheathen]

i drilled the rivets out with, 1/4" bit, i think......came off like butter