robert0762 Posted May 23, 2010 Report Posted May 23, 2010 I currently have a 4 mill mx port with pc pipes boyesen dual stage reeds 28 pwks and a k &N with no lid. If i run pods will io get any more power and if so where in the power band. My setup is not top end so i dont know if it will benifit me Quote
GrMeyer Posted May 23, 2010 Report Posted May 23, 2010 More air ='s more power. You will have more power all of the rpm range. Its all I run but then again I dont run in water or mud. Quote
robert0762 Posted May 23, 2010 Author Report Posted May 23, 2010 Well i have some that i got with some other parts and was thinkin bou runnin them when i go to the mx track Quote
madjimmax Posted May 23, 2010 Report Posted May 23, 2010 For sure the power increase is everywhere. The only down fall is the water thing I just changed to pods during my rebuild and I like it a lot. If your still tuning you should do it before you get it dialed. I don't know if your in state or not, but me and some other boys are going to Greenridge next weekend I'm going on Thurs. and coming home on Mon. If you can make it you should make the drive about 2hrs or so from Balt. Quote
GrMeyer Posted May 23, 2010 Report Posted May 23, 2010 It also makes it a hole lot easier to change jets. Because then you dont have to reset the carbs back into two boots... Just run outwears on them and you will be fine. You need every amount of air you can get on the mx track to pull on people. Just make sure your jetted right so you dont run lean and melt a piston down. Just remember it is easier to jet up then it is to jet down and melt a piston. Quote
thegod81 Posted May 23, 2010 Report Posted May 23, 2010 I am in glen burnie also June 4-6 we r going to breezewood proving grounds. We have a big cabin any of yall want to come? How much does greenridge cost? Do you have to do anything special to your banshee to ride there? Quote
madjimmax Posted May 24, 2010 Report Posted May 24, 2010 I am in glen burnie also June 4-6 we r going to breezewood proving grounds. We have a big cabin any of yall want to come? How much does greenridge cost? Do you have to do anything special to your banshee to ride there? All you have to do is go to DNR and get a ORV permit they cost $15 and are good for the year. You need helmet goggles and sparkys even though I've never seen them check for the sparkys. You can also get the permits at the Greenridge park office. Quote
thegod81 Posted May 24, 2010 Report Posted May 24, 2010 Where do you get spark arrestors? How much do they run? I never used them before, are they hard to install? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.