Darthwall Posted August 29, 2009 Report Posted August 29, 2009 ok puting the clutch side together right now I put the rod in then the ball and then the bearing and there is quite a bit of slack in between the preasure plate and the bearing what is it supposto be like I have two of the ball bearings in there for a mock up but there is still room to go Quote
zephyrdog Posted August 29, 2009 Report Posted August 29, 2009 ok puting the clutch side together right now I put the rod in then the ball and then the bearing and there is quite a bit of slack in between the preasure plate and the bearing what is it supposto be like I have two of the ball bearings in there for a mock up but there is still room to go Make sure your pressure plate is on the correct way by lining up the arows. Then use the adjuster screw. Quote
Darthwall Posted August 29, 2009 Author Report Posted August 29, 2009 Make sure your pressure plate is on the correct way by lining up the arows. Then use the adjuster screw. ya thanks I figured it out im a dumbass sometimes lol Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.