Loc Posted April 29, 2009 Report Posted April 29, 2009 I ran my 2004 banshee on the dyno today and noticed that it might be running a little lean in the mid range and a little in the top, nothing drastic. However it was only 60 degrees today. I will be riding in OK Little Sahara this weekend and it is supposed to be 20 degrees warmer. Should a leave things where they are and give it shot down there, or should a move my needle to say the 4th clip and see if that fixs the problem. Quote
278 Posted April 29, 2009 Report Posted April 29, 2009 If its warmer the air will be less dense you should be fine Quote
AKheathen Posted May 1, 2009 Report Posted May 1, 2009 leave your needle where it is, and up one on the mains. do a plug chop when you get there, and bring the tools to put your current jets back in if you'r rich when you get there. humidity difference will play a factor, and it's better ro assume it'll be alot dryer than risk being lean all day, or however long it lasts. :thumbsup: Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.