Darthwall Posted December 25, 2008 Report Posted December 25, 2008 I have 4 mill stroker 66mm pistons trail port +4 timing 18cc domes LRD adjustable pipes & silencers stock gears just curious if anyones around the same? make it a little easyier on me Quote
wesw Posted December 25, 2008 Report Posted December 25, 2008 would start at 50-55 pilot depends on what needle you have 150-155 mains lot depends on your porting and shit. also you will need a carb sync tool. good carbs. Quote
Darthwall Posted December 29, 2008 Author Report Posted December 29, 2008 would start at 50-55 pilotdepends on what needle you have 150-155 mains lot depends on your porting and shit. also you will need a carb sync tool. good carbs. well needle is R1468N they have 42 pilots and 140 mains right now and needle is 3rd clip from top I havent ran these thats just what they came with Quote
98_shee Posted December 29, 2008 Report Posted December 29, 2008 well needle is R1468N they have 42 pilots and 140 mains right now and needle is 3rd clip from top I havent ran these thats just what they came with You should order a set of cel needles, Im running pretty close to the same set up as you, with cel's 48 pilot, 158 main. Quote
Darthwall Posted January 17, 2009 Author Report Posted January 17, 2009 cool man ordered all the stuff threw it together tonight and the plugs look great thanks alot Quote
98_shee Posted January 17, 2009 Report Posted January 17, 2009 I was just kinda curious where did you end up with your jetting? Quote
Darthwall Posted January 18, 2009 Author Report Posted January 18, 2009 well the juggs are a different set they are a full drag ported but put the CEL needles in on the 3rd clip installed the 158's and 48's and its running a little rich but preatty damn close! idels are up about 1/8- 3/16th took it through 6th and checked them and they look fine so until I get as set of pipes to match it will be OK thank again 98_shee Quote
98_shee Posted January 18, 2009 Report Posted January 18, 2009 well the juggs are a different set they are a full drag ported but put the CEL needles in on the 3rd clip installed the 158's and 48's and its running a little rich but preatty damn close! idels are up about 1/8- 3/16th took it through 6th and checked them and they look fine so until I get as set of pipes to match it will be OK thank again 98_shee Glad i could help! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.