rla_banshee Posted September 22, 2008 Report Posted September 22, 2008 (edited) first any ideas why the old owner did? will it harma anything? banshee wont idle have to hold throttle down to keep on! any reccomendations on jetting? fmf fattys, power cores, dyna fs, 2-1 carb setup on a 32mm keihin carb open clamp on filter! please help me out guys first banshee! also has problems starting at times take a few kicks what can that be? Edited September 22, 2008 by rla_banshee Quote
rla_banshee Posted September 22, 2008 Author Report Posted September 22, 2008 anyone ??? this banshee has me like Quote
Paddleboy Posted September 22, 2008 Report Posted September 22, 2008 you are going to for sure need to put a main jet in there. not too fimiliar with 2 into 1 so maybe someone else can tell you what one Quote
rla_banshee Posted September 23, 2008 Author Report Posted September 23, 2008 you are going to for sure need to put a main jet in there. not too fimiliar with 2 into 1 so maybe someone else can tell you what one now i need to know proper jetting Quote
J-Madd Posted September 24, 2008 Report Posted September 24, 2008 I had a carb that liked to drop the main jet in the carb bowl. Ran fine up to 3/4 throttle, but when it was pinned, sputtered terribly. The needle controls most of the fuel delivery off-idle up to 3/4 throttle. If you had no main jets, I'd guess the previous owner took off the carbs he was running and had those carbs lying around, and put them on there. I've got a few sets of carbs that I've robbed a jet or 2 out of without remembering. Quote
J-Madd Posted September 24, 2008 Report Posted September 24, 2008 Re-reading your post, I bet the previous owner had a 35mm carb on there, and threw the 32mm on when he sold it. You don't see many 32 mm 2 into 1 setups (or any 32 mm carbs for that matter), I don't think. The carb is probably not even close to being jetted correctly for your motor... Quote
rla_banshee Posted September 25, 2008 Author Report Posted September 25, 2008 Re-reading your post, I bet the previous owner had a 35mm carb on there, and threw the 32mm on when he sold it. You don't see many 32 mm 2 into 1 setups (or any 32 mm carbs for that matter), I don't think. The carb is probably not even close to being jetted correctly for your motor... yah i thought so. any idea on jetting for it? and if thats the reason why it wont idle on its own? Quote
J-Madd Posted September 25, 2008 Report Posted September 25, 2008 yah i thought so. any idea on jetting for it? and if thats the reason why it wont idle on its own? Idle screw, air mixture screw, and pilot jet is the only thing that should affect idle. One or all of those could be wrong for your motor. I have no idea where you would start with the jetting with the 32 mm 2 into 1, sorry. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.