Farmtruck Posted September 1, 2008 Report Posted September 1, 2008 Ok We put a tors removal kit on my buddies shee and can't get it to idle can get it close but when you rev it it takes a long time to idle down 10-20 seconds have played with the idle screws and airscerws they are about one turn out it has 17cc domes pro curcuit pipes and k&n filter in the stock air box no lid +4 timing Quote
pabansheematt Posted September 1, 2008 Report Posted September 1, 2008 Ok We put a tors removal kit on my buddies shee and can't get it to idle can get it close but when you rev it it takes a long time to idle down 10-20 seconds have played with the idle screws and airscerws they are about one turn out it has 17cc domes pro curcuit pipes and k&n filter in the stock air box no lid +4 timingDid you grind the side of the carbs down. If you did'nt grind the side down the idle screw will not go in far enough to make it idle. As for it taking a while to idle down, I would look how far you have the throttle cable adjusted at the carb tops. Quote
Farmtruck Posted September 1, 2008 Author Report Posted September 1, 2008 Did you grind the side of the carbs down. If you did'nt grind the side down the idle screw will not go in far enough to make it idle. As for it taking a while to idle down, I would look how far you have the throttle cable adjusted at the carb tops. Yes they were ground down the screws will move the slides. Quote
pabansheematt Posted September 1, 2008 Report Posted September 1, 2008 Yes they were ground down the screws will move the slides.Only thing I can figure is you have the cable adjusted up to much. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.