[Wont start unless starter fluid or petrol in cylinder]

On 03/08/2018 at 10:24 PM, ZillaFreak said:

what is your elevation?

62 ft

[Wont start unless starter fluid or petrol in cylinder]

It Wont start unless starter fluid or petrol in cylinder

It has 100 psi both cylinders stock bore oem pistons

290 main stock pilot FMF pipes and boost bottle 

Why wont it start cold the bowls are correct the choke tube is in there once warm it runs fine but then left overnight i have same issue

[421 Build 2005 YFZ350]

I want a good power gain like a 421 or 4 mill stroker mainly ride trail or what are some other good power gains ? Cost friendly 

I plan on running 98 pump 

I have FMF Pipes 

236 Feet is my altitude above sea level

 

[2001 Banshee 350 Build]

1 hour ago, VegasJeff said:

I have a set of fatties for $140 shipped in the u.s. they have some surface rust and a few small dents.

You can text at 702-501-8770 if interested..

Sent from my LG-TP450 using Tapatalk
 

Im in Australia

[2001 Banshee 350 Build]

13 hours ago, Ayesully810 said:

Only bore to the next size if you need to, there is no power increase.  As far as combos the options are endless and it all depends on how much you want to spend.  If it were me on a tight budget..send your cylinders to get bored (if need be) and ported, send to a builder ON HERE that is an hq sponsor (fast, driveline, redline, Mac daddy, hjr, there are more) welded crank, added compression, timing and a nice set of trail pipes would give you a fun setup for the trails.  Oil ratio you can run 40-1 with a good oil like klotz super tech or benol.  Benol will separate in colder temps just an fyi. 

I can get cheap FMF fattys for it 

[2001 Banshee 350 Build]

Hi Banshee HQ. 

I'm on my way to picking up this 2001 Banshee, It is in boxes & will require a full motor rebuild. 

Asking what are some affordable combo's, I'm mainly riding trail so Im thinking of boring the stock cylinders to a 65.0 

What Exhaust, Tyres, Stock Carb Jetting, Oil:Fuel ratio. 250ft to 590ft above sea level 

Plastics are sanded previous owner sanded them the front are drag cut. I want it to look as original as possible I don't mind blue or silver frame with blue plastics and original graphics kit

How can i bring the blue back off the plastics. or what paint can i use and which process is good to use. 

 

Images:

https://postimg.cc/image/3ki38z47x/

https://postimg.cc/gallery/w3c8ybf2/