[Rebuilt carbs and now won't start]

Not the coil?

[Rebuilt carbs and now won't start]

It's not getting any spark for some reason is there anyway to test the coil??

[Rebuilt carbs and now won't start]

Put new plugs in and still nothing

[Rebuilt carbs and now won't start]

Tried the hose and tried kicking and pull starting again with no luck. It doesn't even really try to fire it just pops really bad. Installed new plugs(without hose on) havnt tried new plugs with hose on now. New plugs are very black also. New plugs again with hose on?

[Rebuilt carbs and now won't start]

It didn't get hot enough to blow it up I

Mean it tried to bump it and back fired and fell on its face and i stopped. Didn't let it over heat. Have 110psi ish on both cylinders on compression t st also

[Rebuilt carbs and now won't start]

No super long. What kind of damage are we talking?

[Rebuilt carbs and now won't start]

Yep. Not able to give me a call are ya lol

[Rebuilt carbs and now won't start]

Ok gotcha. Then there right throttle works fine slides easy.

[Rebuilt carbs and now won't start]

I already had them plugged in I can try unplugging them. I don't see that dot on the slide ether in the picture. Is it only on one slide? If so which one?

[Rebuilt carbs and now won't start]

Pic won't upload. What does this do unplugging it? Unplug the tores also?

[Rebuilt carbs and now won't start]

All three? Thought there was only 2. I only unplugged 2 so if there if a third it should still be connected.

[Rebuilt carbs and now won't start]

Just for kicks and giggles how do u know what slide goes on what side

[Rebuilt carbs and now won't start]

Yep marked the slides also. Left the main and pilots the same since the rebuild kit came with stock ones since these ones where not

[Rebuilt carbs and now won't start]

Yep I kept them separate when I re did them

[Rebuilt carbs and now won't start]

Just put one on and still won't kick start

[Rebuilt carbs and now won't start]

Negative

[Rebuilt carbs and now won't start]

Basically just put a new float jet in it and that's all. Was leaking gas out the over flow so float was sticking more less. Won't kick and start. Just pops and backfires and gets really hot when pull starting it. Any ideas? 98 banshee. Motor is basically stock from what I know about it has fmf pipes and slip ons and jetted. Ran fine until it started leaking gas.