dirtydownunder

There was tests done with t5s on a serval a long time ago with shearers and CPI, the t5 sucked in the top end. (if you believe that dyno stuff) but I had t5s on my serval and the top end felt way weak. I Swapped to shearers and felt they had more power everywhere, even the bottom end, and pulled way way more in the top end. I trail mine sometimes and the down low is fine. But I don't do any first gear stuff. Open trails usually.

coz they fit

Yeh, more or less.

Turns out the snipers have more curve, go figure ?

Haha you guyths, So thilly

are you racing in any of them brett ?

could be plug caps or wires. ohm the plug caps.

Secret squirrel bidnes.

run what you already use. ive never used different oil or ratios for break in, hey i dont even do break ins. unless i need some cash.

way too long of a story. you lost me at, "ive"

get some cheap stock carbs, and run them on the 4mm, when ever that happens. then buy bigger carbs later.

oil.

yeh its a sham, no way gsp won that.

yeh i reckon gsp lost it.

good fight so far.

i got vf3 now, if i were to buy new ones, they'd be vf4, for no real reason. tho the vforce have twice the amount of petals and dont have to open as much to move the same amout of air compared to other reed cages.

just get some vf4 they are around 200 chariot/ boyesen is about 170. same same, you prolly wont even notice the difference.

replacement reeds for boyesen's ? cheapest option ?

changing my cerrone to dunham. dunham is pretty good.

gsp by boring win. sonnen by domination, i dont even like sonnen, i hope evans KO's him lawler by ko/tko koschech by hope. cerrone herman story

as long as both surfaces are clean and flat, most gaskets are good. cometic make great gaskets, ive used them and k/s, i use k/s for their seal kits too. depending on what size base gasket you run, if its .020" cometic make an AFM gasket, id use one of them, compared to a paper gasket. tho im running .012" so i just run any paper gasket. much the muchness, just make sure shits clean and flat.

Is that a comedian in ya exhaust, or does that just sound funny ?

And they sound funny.

It will, an easy 15-20HP over a stock, piped banshee. Get the crank trued and welded.

Can go broke saving money. Don't know how people keep falling for these.