Schrader

Hey guys I got it it was the reed I had some after market vforce3s in and the right side was frayed at the end I put the stock ones back in and it was doing the same thing so I put new plugs in must have fouled the plug but it’s running good on both cylinders now thank you for your time and advice I hope this will help someone else out

I think I may have figured it out I pulled the reeds out and the ends were frayed I’m going to put the stock ones in hopefully that’s the problem and it does make sense to me I’ll give you guys an update later

I don’t know if I can put a video up but I have videos of before when it ran on both cylinders idling. Then after I cleaned the carbs idling on one cylinder it blows cold air but will blow blue smoke every once in a while not sure if seeing a video would help but lmk

No luck yet I think I’m going to go through everything one more time to make sure I didn’t miss anything then I might take it somewhere for some help but in the mean time of you guys think of anything let me know thanks

I don’t think it’s flooded when I pulled the spark plugs I blew the cylinder out and let it dry for a good hour started up with a few kicks did the same thing. What should I do if you think it is flooded

I got it from my neighbor he said he did a compression check when he first got it from an auction he said he had about 110-115 if I remember correctly. The fuel in my exhaust was from running it a while not from trying to start it it’ll start first few kicks it was running with the choke tube off I put it back on didn’t make a difference. I’ll go check out the reeds right now

Put the choke tube on didn’t make a difference when I first got it I put some stock carbs I got from a guy and I never hooked up the choke tube and both fired then it sat for a while and that’s when the right cylinder started to stop firing it shouldn’t be the carbs though because I swapped them and I just swapped them back and put the tube on and I think since both sides were the same it might not be accurate but they are both consistent

I didn’t know the slides matter what carb you put them in I tested compression I got about 105 in both I don’t think its flooded because it started right up and was running one on cylinder. I don’t have the choke tube hooked up though could that be it

It will run just the one side won’t fire I don’t think it’s spark or fuel because I swapped everything and the left side still runs strong

Just did that a little bit of fuel cane out it was black

My banshee would only fire fine until I hit a higher gear then the right side would shut down and fire every once in a while. I took carbs off cleaned them put them back on now it doesn’t fire at all it will blow smoke sometimes and back fire it is leaking out of exhaust and getting gas I’ve swapped spark plugs, wires, carbs hasn’t changed it has the tores delete idk what else it could be