Guest utleybanshee Posted March 20, 2008 Report Posted March 20, 2008 new pistons, crank, and seals, now left cylinder has 150psi and the right has 75 psi i can't figure out y i also have a cool head... there are no scars in the cylinders either... any advice would be appreciaited. Quote
Hilarious Posted March 20, 2008 Report Posted March 20, 2008 Were you careful to make sure the rings didnt move around on the piston, off of the locating pins, as you were installing the cylinder in question? :shrug: did you check ring gap on both cylinders? Quote
Guest utleybanshee Posted March 20, 2008 Report Posted March 20, 2008 yea im pretty sure they are in the right spot Quote
Guest utleybanshee Posted March 20, 2008 Report Posted March 20, 2008 i just spent like 700 in the damn thing and im gettn fed up i had a raptor 660 stroked to a 720 and never had a problem switched to the banshee and now this.. Quote
bansheejoel Posted March 20, 2008 Report Posted March 20, 2008 if you dont like it sell it!! :yucky: Quote
FasterThanU90 Posted March 21, 2008 Report Posted March 21, 2008 the piston rings are probably directional and you installed the low psi. cyl. rings upside down look for a mark toward the end gap this should face up Quote
Guest utleybanshee Posted March 21, 2008 Report Posted March 21, 2008 thanks i'll check it out in let you know.. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.