Another jetting question

[Male Supremacy]

Well I'm almost done putting this thing together. So many new parts here in the last month or so (a-arms, shocks, pipes, carbs, etc.)

 

I've just got these 30mm carbs, so does anybody know how I should jet them for these two elevations?:

 

1. Sea level

 

2. 5,300 ft.

 

You can check my sig for the mods I've got...most notably the CPI inframes. I've got the carbs out and ready to jet them before I put them on. Any suggestions would be awesome.

 

Thanks!

 

Eric

[Male Supremacy]

bump

 

 

Any suggestions at all where to start???LOL

[Male Supremacy]

OK, so,

 

30mm carbs,

CPI's,

VForce III Reeds,

Dual K&N's,

RS Timing plate +4,

Bored .40 over,

Wiseco Pistons,

Cool Head with 20cc domes,

 

I just don't even know where to start. Any suggestions would be great. Just the sea level setup would be greatly appreciated. It's the carbs that are throwing me off.

 

Thanks!

Edited March 10, 2008 by Male Supremacy

[slowblueshee2]

OK, so,

 

30mm carbs,

CPI's,

VForce III Reeds,

Dual K&N's,

RS Timing plate +4,

Bored .40 over,

Wiseco Pistons,

Cool Head with 20cc domes,

 

I just don't even know where to start. Any suggestions would be great. Just the sea level setup would be greatly appreciated. It's the carbs that are throwing me off.

 

Thanks!

I am not familiar with 30mm carbs but i would guess somewhere from 150 to 160 mains and 50 pilots oughta be a good start point. I ran 28pwks with 150 mains and 50 pilots on a ported 350. I stroked it later and ended up at a 145. That should be close enought to get you going.