lineybiker_11 Posted February 28, 2005 Report Share Posted February 28, 2005 i hear on here that you guys set your float hight but i'm not sure how. how do you do it and what does it do for your carberation. because the carbs were off this thing for like 4 or 5 years because it was my dads and it sat in the garage and i pulled it out and fixed it so i think it could be off from sitting. Quote Link to comment Share on other sites More sharing options...
blk02banshee Posted February 28, 2005 Report Share Posted February 28, 2005 Measure from the base(where the float bowl contacts the carb) to the bottom of the float( well, Top, since the carb must be upside-down to do it.) Quote Link to comment Share on other sites More sharing options...
lineybiker_11 Posted February 28, 2005 Author Report Share Posted February 28, 2005 what should it be at? Quote Link to comment Share on other sites More sharing options...
blk02banshee Posted February 28, 2005 Report Share Posted February 28, 2005 I don't remember, but I think it's 20-22 mm. I could be wrong, though. I use a vernier caliper to measure. Quote Link to comment Share on other sites More sharing options...
dajogejr Posted March 1, 2005 Report Share Posted March 1, 2005 21 mm is correct.... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.