SiCkBaNsHeE_990 Posted May 23, 2004 Report Posted May 23, 2004 I have K&n filter, 2 into 1 exhaust, like .50 o.s bore and im around sea level. What jets should i use? and if it matters i have a boost bottle. Quote
SiCkBaNsHeE_990 Posted May 24, 2004 Author Report Posted May 24, 2004 oh ya and i have a lid just no snorkal Quote
SiCkBaNsHeE_990 Posted May 24, 2004 Author Report Posted May 24, 2004 Put it this way I went from duals to the 2 into 1 and now it feels sluggish. Quote
sredish Posted May 24, 2004 Report Posted May 24, 2004 what other mods, what jets do you have in it currently, what air filter are you using? It's feeling "sluggish", where; offidle, full throttle, half throttle?? Quote
Foobie Posted May 24, 2004 Report Posted May 24, 2004 Ok here is my setup, hope this helps. Stock motor 2n1 Dynoport Stock carbs Airbox lid off K&N with proflow adapter Reed spacers FMF Carbon fiber power reeds I run amsoil synthetic at 50:1 Jetting: Stock pilot 1.5 turns out Stock needle one notch down from stock (richer) 310 mains You could try the same as mine just run 290s since you have your lid on maybe even 280s. Just do a plug chop to verify. It runs stong. I was having a problem with over heating so I went from a 300 to 310 just to see if that helped and damn I found more power so I must have been running too lean. I am going to try 320s this weekend to see if I can find some more! Hope this helps. I used the Banshee jetting guide in the FAQ section to get close with my mods and it took alot of the headache out. Dustin Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.