How to cut banshee front plastics.

[2005she]

i want o cut my front plastics but don't know how to or what is the best and easiest way to do it.

Any suggestions

[vrx46]

heat gun and exacto knife, and some patience

[Burke]

measure, measure, and measure again to make sure your sides are even... tape them off and use a cutoff wheel and leave just a tiny bit of material to file off.  File it down perfectly straight and even from side to side and "polish" the edge back up with a heat gun

[possum]

I use a cutoff wheel. But im good with it. I use it all the time

[5150banshee]

Measure, tape off, make sure they both are dead on the use grinder with a cut off wheel. You can sand the edges down after to smooth out.

[2005she]

What if I don't have a heat gun

[Burke]

Hair dryer or a torch... Gotta be careful not to melt them though

[willaduncan]

Dremel with plastic cutting wheel, tape the line, cut slowly and precise, once done pull tape and hit the edges with a pencil torch (take your time to get the feel for how much flame is needed to form the edges.

 

 

Sent from my iPhone using Tapatalk

[2005she]

Thanks

[90Bansheedude]

Look at pictures of one you like and then tape them off with masking tape like mentioned.  I actually used a jigsaw with a good sharp fine blade on it and a belt sander and a sanding block to make sure they were straight, but i was painting mine.  I have actually seen and would like to try sometime a cutting attachment for my soldering iron (the trigger style with 2 ends coming from the tip) as i think it would be like cutting butter with a hot knife.