mvvette97 Posted November 12, 2014 Author Report Share Posted November 12, 2014 Then there is no need for a spacer plate. That's what I was wondering. I ordered a .020, .030 and a .040 base gaskets but not sure what one to use. I tried to mease the old one and it looks like it was about a .035 thick on the outside edge but where is had been compressed was about .025 or a bit less Quote Link to comment Share on other sites More sharing options...
mvvette97 Posted November 12, 2014 Author Report Share Posted November 12, 2014 By the way what size is my engine? .040 over bore with the 4mil stroker Quote Link to comment Share on other sites More sharing options...
Bennett131 Posted November 12, 2014 Report Share Posted November 12, 2014 Quote Link to comment Share on other sites More sharing options...
Bennett131 Posted November 12, 2014 Report Share Posted November 12, 2014 I can't tell you what base gasket to run, you will have to check your squish and move forward from there. Quote Link to comment Share on other sites More sharing options...
Bennett131 Posted November 12, 2014 Report Share Posted November 12, 2014 Pic looks kinda small to me...if you can't see it, it's 385cc. Quote Link to comment Share on other sites More sharing options...
mvvette97 Posted November 13, 2014 Author Report Share Posted November 13, 2014 Pic looks kinda small to me...if you can't see it, it's 385cc. Thanks man, that's a good chart. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.