Tors Removal Kit question

[corypro]

Does anybody know how much these run for? To remove the tors on my Blaster all I had to do was remove the module and close a wire circuit located in my throttle box. With the Banshee it seems a little more than that and it looks like you actually have to acquire replacement throttle cables and more. From your experiences, can I go about removing the tors without this kit or no? If no, I've seen kits around $60 but shipping to my area would be another $30 so I don't know if it's really worth it.

 

Any input would be appreciated

 

Thanks@

[rdzbangshee]

you will need a different cable and carb cap kit . just disconnect the tors on the carb and cut the wires on that electric throttle cut off switch and call it good

[Larry's Shee]

You can do it like you did on Blaster , or get kit , install idle screws, new cap & cable, disconect box.

[bansheesandrider]

All you have to do to DISABLE the TORS on a Banshee is unplug the little black box under the left side of the fuel tank next to the coil. If you want to remove it, you need a kit with a cable, carb tops, cable adjusters and an idle screw kit. If the box is unplugged, you don't even need to unplug the carbs or thumb throttle.