name these carbs.

[Phelps]

i need to order parts and rebuilds for them and have no idea what they are other than 34mm mikuni's. they have a remote choke cable. any help would be appreciated. and no there is no vm part number anywhere that i can see.

[Larry's Shee]

Done polished the numbers right off them , eh ? JK . NFC.

[Phelps]

Done polished the numbers right off them , eh ? JK . NFC.

there was actually no numbers before i started the polishing process.

[RadarRacing]

look like 34mm mikuni VM carburetors. Very common carb on snowmobiles and even sold by come cos for banshee applications. Tony Ducas Racing sells em I know. If you need parts for them any carb part co such as Carb parts Warehouse or Sudco should be fine. They usually have fairly rich needles in them for gas banshees and you have to raise clip/drop needle a couple clips. I may have a few parts if you tell me what you need. You also can get a plunger choke assby for them.

[ELKARACING_SHEE]

those are the stock rz350 26mm mikuni carbs. Its just their old style, and the banshee ones just looke different that is all

[Phelps]

those are the stock rz350 26mm mikuni carbs. Its just their old style, and the banshee ones just looke different that is all

dude these are not 26mm carbs.

 

anyways thanks radar i will be sending you a pm.

[Snopczynski]

Its a Mikuni VM, size is whatever the neck inner diameter is.

[camatv]

34mm remote choke means snomobile carbs from the 80's. they are also probably set up for a pump might need to check the float needles.

 

34 pj's would work better than those also. the round slide type carb is a bad design.

[Phelps]

34mm remote choke means snomobile carbs from the 80's. they are also probably set up for a pump might need to check the float needles.

 

34 pj's would work better than those also. the round slide type carb is a bad design.

honestly i was just going to polish them and sell them cheap. hell right now i would just be happy to get half my money back that i have in them.

[AKheathen]

just std vm carbs. size is stamped on the side of the bor in the 2nd pic. they will accept a normal plunger/lever choke. the cable is an upgrade, imo. x2 on checking the float needle. pumpers use a smaller oraface, if i remember, but might just need different adjustment.