Abe

My play axle is definately wider than stock with the hubs all the way out, even with with stock offset wheels And btw jja is actually cheaper than the steel axles considering it comes with all new hubs. Add in the cost of a full set of billet hubs to the steely and you will be better off going jja

I have a nice 6 pack rack that you can pull a pin and have a standard grab bar. $70 shipped. With rack with out rack

Very clean looking ride

Swap and trade section, a guy there wanting to trade silver fullbore to white oems

Eat your heart out dave ..... carbs are sold

^ go drink some geritol and come back in a better mood old man

Ttt somebody needs a deal on a brand new setup.

^^ the bhq jews lol

If ya need anything on trade lmk

Brand new 39mm pwks and Upp intakes. Neither has ever seen fuel. $400 shipped you cover the fees or gift. FIRM

Sold

Like title says 37 lectrons on gas. One carb bell has an extra power jet hole that has been epoxied, 2nd pic shows the repair. Cable in picture is included and works but I believe it may actually be a mikuni cable. I know nothing about these other than they came from a running 392 cub motor. $265 shipped firm with gifted payment or cover the fees

Well I didn't recieve the spacers. I've never had a problem with ship time from atv galaxy but I will say this almost every order I have made has been missing some type of part, hell even my levers were missing the dust covers. Now for the good side they have the best prices I've found and have always shipped my missing parts right out after a phone call. Considering I'm missing this adjustment shim this makes the 4th missing part they have had to ship me within 5 orders. Imo the way the parts come packaged they are buying up damaged or over stock stuff to offer the lowest prices

I criss cross my lines and that gives ya a little smoother path away from the pipe

How's the upper shock/struts mount ?

Old men ask too many ?'s. I got a good story to share with ya dave

Gave up on it huh ?

Can probably pick it up new for what freight is gonna cost

Yeah if something internal was messed up the actuator and arrow wouldn't be aligned correctly. And the clutch works fine just has too much free play without adjusting the perch all the way to the max or shimming the cable out at the cases. These are f3 levers. One thing that has crossed my mind to check is the actuator arm, it is a new oem unit but I'm going to compare the cable attachment to an old one to make sure they haven't changed nothing around with superseeded part numbers or something

My stuff is all brand new , never ran windy. Oem inner hub and pressure plate with Mattoon basket and lockup. Has a chariot pancake bearing with new rod and ball and a drive line clutch

Yup as to adjust the reach ?

Hope not tricked , I got them from atv galaxy any give aways for the fakes ? I do know there is no way I could run the motion pro cable and really the oem was too long before I put an extra washer between the cable and the forks on the case. I don't have another perch to see if the problem persists but since the actuator is actually adjusted to engage just a hair before the alignmen arrow I see no where else for it to be.

Anyone ever have a problem with their clutch cable being too long with a asv lever ? Motion pro cable was too long to have adequate threads left in the perch so I swapped in an oem with a washer to shim it out at the case hold down and it's working now but is still adjusted out a little more than I like at the perch, and yes the actuator is properly adjusted

What's wrong with tranny ? I have a complete spare but the snap ring groove is bad at kick start idler gear. Make you a good deal if ya want it

I'm usually not a betting man but I'd lay $50 he's never seen a set of inframe shearer's other than in those pics he sent you