duneloon

I would bet you are using your 4mm crank in your cub. If not let me know I was thinking of keeping this stock stroke. If I can come up with a good deal on a crank I will give you a shout.

What year, condition, and modes. And can you send some prices on it and on parts. Thanks

I am needing a project, so I can keep my hands away from the recently completed Banshee :thumbsup: . I have some cases but need the rest. I am shure that every one has at least one iteam they don't need and would like to part with.

The guy has another crank he can pull one out of. Thanks for the info

Can the placment pins on the bearings be pulled and replaced? Thanks in advance. I sold a oem crank to a guy on here and he found that one of them had been smashed down slightly. I want to get him up and running as soon as possible. I do not now how badly it is damaged I must have over looked it.

stator sold

PM sent

I would say it has around 20 hours on it at the most. I had it welded before I put a 358 cub on it. I am selling the bottom end so I can build a much larger one. Sale pending on the trans. I am also selling a rickey stator with adjustable timing for 80 has only been used four times. Anything you can think of in the bottom end is for sale.

I need to sell the complete or part out the bottom end from my "05" bike. All parts are in great condition. Pm with any offers or ?'s on any part not listed. cases 250 welded crank 150 trans 100

cub sold

sale pending

I have some off of an 05

Garden City KS

The deal fell through, so its all up for sale. contact me with any offers and no I will not sell the whole engine for 900$

I think with 150 you are pushing it. I would strongly recomend that you run 50/50. You should notice some gain, but I always run 110 with 180 lbs.

How long has it been since you cleaned your carbs?

I would say you should find the place that is going to do the cub and see what they will recomend. I would never see paying to port cylinders when you only plan to run them half of a season. If you just can't wait I would look into r&b porting they run auctions on ebay. R&B is cheap and good. Just my .02

sold

Yes

Thanks man any one with an offer for anything in the engine pm me

Yes I am the one that finnaly got the cub from him. I got it planet sand I hope that this will give it some exposure. I have talked to Kolby(jeepman) numerous times on the phone and have sold him my 38 cv carb. I think it may be a good idea to bring some of this up again considering the TOOL still owes me 78$ or some K&t domes cut for it. I am shure that I will never see any of them ronnie replied to a pm I sent him on august 6th so I am not shure if he is banned or not and ronnie if you reed this you better not send me the damb big bore domes you couldn't figure out I want the money! And there is no porting on it like he stated

I am selling a 358 cub with 6 hours on it with wsm pistons with one hour on them for 800$. Also my stock welded crank for 150$ I will sell the set for 900$. I am also thinking about selling the complete engine minus carbs and reeds for 1600$ top notch head with 18cc domes complete botom end with all stock parts. The bottom end is out of my 05 and has around 15 hours on it in very good condition. All parts shipped. This is the cub I bought from RSHIEPICK. All parts shipped. I will try to get pics on www.planetsand.com.

how much for the intake

You may want to look at your harnes. make shure it hasn't been burnt throgh to wire. Did you mod. it while it was apart