Jump to content

No spark! Changed almost everything!!


Recommended Posts

No spark.  Just bought bike. Had it running and now it has no spark.

Checked ohms on stator, pickup, coil primary and seconday, wires and caps. ALL.TEST GOOD. Continuity in on/off/light switch is good....(although it beeps continuity on OFF. Dont think this should effect spark as long as i have it on OFF, aka, the new ON.) Key switch has good continuity.

Has a tors delete. Everything unplugged and/or cut.

BRAND NEW. I replaced or replaced with:

Flywheel, Stator, wire harness, key switch, cdi box stage 2 , voltage regulator, keyway, dynatek coil

Only thing i didnt test was cdi box because i couldnt find anything on that.

Link to comment
Share on other sites

Did you try a new stator or test it only? I've tested stators that tested good and were not. If you haven't tried one see if a friend will let you pull theirs to try it.

But, your switch comment is a bit confusing. You do not want the run switch to "beep" continuity to negative in the run position. 

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...