Jump to content

Banshee


Recommended Posts

I have a stock  banshee motor, stock bore(64mm wiseco)stock stroke, stock intake boots with stock cross tube, v force 4 reeds, timing it set at 10, 120-125 psi, pro circuit pipes, jetting/pilot 150,42 I’m running a set of 28 keihin carbs, k&n filters. Air screws are at two full turns out,and clip on needle is set at second notch from top, Elevation 505’  idles fine and are sync, but shee has a bad bog going up hills and will act as if bike could be needing more gas when just cruising a open field until you go up pass 3rd gear clears up pretty well, can someone give me some advice that will put me in ball park thanks in advance.

Link to comment
Share on other sites

Timing is at +10? Max I ever ran was +4. If it's a bog it's to rich, popping is lean. I'd try different set of needles if your at 2nd slot and it's still rich. I'm not expert though I haven't played with banshee's in years. Got the bug again and will be re-learning though.

Edited by SandSlingerOR
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...