caleb90 Posted August 8, 2020 Report Share Posted August 8, 2020 so i wound up with a wiseco 65mm rebuild kit and a set of niche jugs and a yamaha head, in a trade for the oem carbs i had gotten. pulled my jugs off and hardly a scratch, pretty sure its the stock bore i still need to measure. not wanting to punch my cylinders out .40 if not needed. i thought i will just get the niche cylinders punched out. good god there terrible looking, rough casting in every port none of the ports are chamfered. before i even attempt to take them to the shop to get bored im going to have to dremel every thing down.. hoping i can get by with my stock bore with a fresh hone and rings Sent from my SM-G920V using Tapatalk Quote Link to comment Share on other sites More sharing options...
375hp banshees Posted August 8, 2020 Report Share Posted August 8, 2020 Just bore oem & be done...thank me laterSent from my SM-A505U using Tapatalk Quote Link to comment Share on other sites More sharing options...
caleb90 Posted August 8, 2020 Author Report Share Posted August 8, 2020 niche jugsSent from my SM-G920V using Tapatalk Quote Link to comment Share on other sites More sharing options...
caleb90 Posted August 8, 2020 Author Report Share Posted August 8, 2020 stockers i pulled off last night, assuming all the brown on the sleeve is from blowbye and dirt.. it wont come offSent from my SM-G920V using Tapatalk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.