Dazeys

Great, thanks for the info. Tony

My 4 mil long rod Banshee runs strong. We ride at the Oregon dunes. It has stock carb bored out to 28mm. Compression is at 180 psi.(110 octane fuel). I have 310 mains in it now. Banshee # 2 has stock head milled and carb bored out to 28mm also. don't know what it has for mains. Just bought it. We are going to St Anthony's over the 4th holiday. They run great at sea level, but St Anthony's is at 4000 -5000 ft. above sea level. What mains should I run there? Just want to get them as close as I can so I can spend my time riding instead of tuning. Thanks, Tony

Just thjinking out loud. Would it be possable to use an automotive leakdown tester on a Banshee? Plug the intake and exhuast , remove 1 plug and put that cyl at bottom dead center. Add 6psi. and watch gauge.

Yes I want them. Meet up on the 30th or give me a total for shipping and I can send via Paypal.

How much to ship to 98223? I need them, I have some ugly T4's now with good stingers and silencers and have been looking tor some T5's.

Pics to Dazeys@aol.com

I have a set of reed spacers, but they don't help. Turnning the carb slightly still will not let them come even close.

Bought some 34mm Minkuni flat slides and a billet intake with built ln crossover. Tried to tnstall them but they won't fit. The right one fits in but the left one hits the pipe. I have Toomey T4's. Do I need to find different pipes or different intakes to make them fit.

Bought some 34mm Minkuni flat slides and a billet intake with built ln crossover. Tried to tnstall them but they won't fit. The right one fits in but the left one hits the pipe. I have Toomey T4's. Do I need to find different pipes or different intakes to make them fit.

It runs strong with the stock carbs. They have 30 pilots and 320 mains. I ride at the Oregon dunes so I'm at sea leavel. The 34's have 280 mains and I can't read the pilot size.

Found some Mukuni 34's with adjustable power jets added. Anyone know anything about power jet and where to start with the jetting?

Yep, I measured them 3 different times just to be sure. I know I need to move up to 33s or 35s. Any one here have any for sale. I would need to put on the intake boots to match also.

Stock carbs are 26mm, but when I measure mine they are 28mm. They look stock. I have a 4 mil and I think I need bigger carbs.

Pull the lever 1/4 of the way in, open the bleeder and pull the rest of the way. Close the bleeder and release the lever slowly. Do the same on the other side. Keep going from side to side untill no more air.

Installing Armadillo +2+1 a-arms. What should the camber and Toe be set at? Should it be set with rider weight? Also I just installed a 4mil long rod engine with 170 psi. Can I get by with a 50/50 mix of race fuel and 93 octane?