SheeBang92

i have a 2003 ltz400 for sale/trade i would like to trade it for any sport quad really above 350 unless it is a 250R the bike has a yoshimura slip on silencer dg front bumper and ac nerfbars stock d.i.d. rear wheels and tires (that need replaced about 10% tread left) and polished front rims and holeshot mx tires also has e meier hood everything seems to be straight on it the engine is out right now because the inner case needs welded i have a couple patches made up for it out of an old set of banshee cases so it can be welded now. i have pictures just text me at 419 908 5918 for a picture or leave an e-mail address and i will send them through e-mail let me know. really interested in a banshee also have some stuff i could throw in on a trade like a nitro r/c car guitar amps snowboards s10 rims and tires car audio anything really let me know.

pictures of the roller pleasse? and will you get me a price i dont want to lowball you but it is an 88 so its the (unwanted) j-arm model...

so i got a 2003 z400 for my banshee but it needs a set of inner cases if anyone has some or knows where i can get some kind of cheap let me know i would appreciate it.

bump

bump

yeah never mind on the aircraft stripper i just tried it on my minibike frame and it wont take it off its too tough it took it off my clutch cover on the banshee around the edge the gasket sits because it wasnt thick on it i guess but yeah get a machinests file and file it on the vin# area then get a can of clear coat or something to seal the metal.

to be on the safe side if mine was registered i would use air craft stripper it wont hurt the frame wipe it off really good afterwards and it wont take long to do.

get a peice of steel wool it wont take more than twenty minutes to get the carbon off both pistons

get a peice of steel wool it wont take more than twenty minutes to get the carbon off both pistons

x2 on that use aircraft stripper on a paint brush numberous times until the powder coat comes off.

is the gear miscolored like does it have a blueish tint to it if so it is getting hot and losing its temper and just shattering are you using the correct weight oil?

ok when i started the banshee up it started running at about half throttle and the barb slides seem to be in the correct position would a cracked intake do this? and if not what else would do it?

i have a motor its bored .040 over drag ported brand new crank and bearings (not sure of crank size) would come with 2 34mm pjs cdi everything to make it run really. i want like 900 plus the ride im in ashland ohio everything is in good shape. let me know

if i have enough interest i will gladly part my engine out or just sell the whole thing for 1000 shipped or 900 picked up. it is bored .040 over has a drag porting cases and jugs both has brand new oem stator good tranny i believe a brand new crank .040 over wiseco pistons and rings stock (i think) reeds 34mm pj carbs have full fmf gnarly system pipes have surface rust nothing wrong with the silencers or i will sell everything if i have some interest or will also trade motor for running 250 dirtbike engine cdi carb throttle the whole nine yards 92 and newer and a little cash. pm or leave me a message here for prices shipped to where thanks alot.

how much shipped to 44805?