Oilsmoke

how much of a swinger you looking for? Looks like a fun test. But i only make the dunes a few times a year.But i am also in need of a rear rebiuld. If that is enough time Pm me. I am also a Old timer so i am some what lesser than agreesive but Still enjoy getting On it.

I was in a chat with Mp350 and I don't think Dave Moore is Dune Gooney. they where partner in MP racing. They split up according to Walter.

Should be a Good race Let us know who wins. Cheetah Cubs are after market cylinders. Cubs and T6 are not your best combo.

I like to know this also.And what would the cost be for a bare unfinished set?

LOL well I don't believe You or your claim.

Thx for the info Wesw Time & money spent. SO how many pulls did you do?

Jim that looks great. What where your Jetting Spec? And tenision setting on the V2? What type porting did you set them up for? I wondered when i bought my Shearers if it was a good choice Being the test bed for this combo. I was never sorry i took this route

About 27cc"s

I may take a jug of your hands for the right price. Front plastic is a maybe too.

Thx for the Spell Check Your Right RedNeck Bullshit sounds Better Nobber Muhehehehe The point is Both Carbs Work Great when Jetted Correctly. It's the Jetting that make the Power Output what is can be.

Personal this is Very Bias statement. Out here is Dune land & Planet sand Forum. A lot of people Run Mikuni's Most Winning Drag racer Use The TMX or TMS for a winning combo. K&T a world wide know Banshee biulder Uses Mikuni, SO I'am not listening to your rederick Biased Bullshit. Like he said if you want more power from a Stroker Cub I would use the tms 38's Keihin are for Kids Mikuins are for champs.

This yeilds 8 inches so 6 to 10 is my range. for quad placement 10 is the best but i need to watch my tongue weight so if 8 will work i will go with that. Thx all for the imput and Quad4me for plans link

Well 60 percent is 57.6 inches. Almost 10 inches. Past halfway of the main frame. Sound like good place for it. IDAHOSHEE I am not an engineer How would I calculate that out? Loaded or unloaded? It will haul 2 quads about 650 pounds plus the trailer weight. So my tongue weight will be fairly low quessing around 375 with 9 or 10 inch past centerline placement. Is this Ok

If thet where yours you would know. Lamer.

I have a single atv trailer. It's over biuldt big time. It's made out 3 inch channel. My plans are to widen it to 6.5 and lenghten it to 8 feet. So it can haul 2 quads sideways. WHeel will be outboard of the frame. SO where is the best place for the axle centerline? any tips guys