Sign in to follow this  
Followers 0
1CrazyBastard

Banshee float level setting

4 posts in this topic

Can somebody tell me if this is the proper way/ place to measure on the inside edge of the carb where the bowl contacts to set / measure the Float level I found this pic after some searching but wanna confirm that its correct and 21mm is the correct spec ??

 

bansheefloatlevelsetting.jpg

Share this post


Link to post
Share on other sites

Yes, thats the correct place to measure, but you need to hold it sideways so that it doesn't compress the spring loaded needle. Tip it sideways with the float pivot pin at the top. Tilt the carb till the float just bumps against the needle. Not sure on spec. Don't have my Clymer here with me.

Share this post


Link to post
Share on other sites

21mm without the gasket.

 

Yeah kinda figured as the gasket is a few mm itself and yes my floats were off a few mm as I wasnt sure about the spring loaded needles and compressing them or not i have got it running pretty good and the floats are at 21mm now Thanks !!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0