2strokesmoker

any body knw or herd any good about the itp sand stars?

300 foot sand drag. What paddles should i run with the mods in my sig. Any help is greatly appreciated.

I belive the ring gap formula goes like this. .003-.004 per inch of bore.......68mm bore converted to inches.....68/25.4=2.677.......so in inches your 68mm bore is 2.677"X.003-.004=0.010708 almost .011. Some one correct me if im wrong........................

^^^^^^^^^^^X2^^^^^^^^^^^^they dont look ported to me in the pics provided.............

extremly low lol. Yea def time for a top end. Becareful with that new top end. If your running way "rich" dont wash the cylinder out!

X2 for lakes motorsports! Mike is a great guy. If your shit aint right hes by your side until it is!!!! A++++++++

I bang the shit out of my tranny....never had a prob yet. I just make sure i change the fluid on a consistent basis. No counter balancer just main shaft and counter shaft.......

check your needle adjustment. mine was to high and washing out the spark......thus dumping fuel into the pipe......

If its the cylinder that does not fire that has low compression then prob need a new tip end. My bike was not firing on one cylinder but when i had my buddy switch the throttle cable he had a little mix up with the carb cap with an extra set laying around the shop. The needle was a notch or two higher and was washing out the spark......but yea if you pick it up i would start with the carbs and spark. Its only three key factors with a two stroke.

I would never put a nos bottle there. Even with the tors kit its not that fun moving around in there let alone with a 2.5lb bottle in ur way.....but any way def get the get the kit, tors are garbage!

I had to get a new top end.....bought some stock bore cylinders and they came with the wiseco pistons. Just honed them and threw some new rings on... Runs Great!!!!!!!! I could't believe the price just for the rings. It was like 30 bucks a side. On the other side i herd replacing the top end every 25 hrs of racing????? True or not idk????

Hold the button asshole! Where the fuck do you see me bashing on marvin shaw shocks? If i thought they were garbage i would of never put them on my quad. Learn how to fucking read douchebag!

everything but the seal kit!!!!!!! Highly recommend it.

Yup me too.....Wiseco def owns hotrods!

They are yfz 450 a arms so they are like +2+1 :biggrin: :biggrin: :biggrin: :biggrin: